MCQs > Engineering & Manufacturing > Instrumentation Engineering MCQs > Basic Instrumentation Engineering MCQs

Basic Instrumentation Engineering MCQ

1. The inverse Discrete Fourier Transformation of x(n), an N-periodic signal can be expressed as ________.

Answer

Correct Answer: 3

Note: This Question is unanswered, help us to find answer for this one

2. A closed loop of voltages is given in the above figure. According to the Kirchhoff's second law, V1+V2+V3+V4= _____.

Answer

Correct Answer: 0

Note: This Question is unanswered, help us to find answer for this one

3. What would be the peak output voltage of a positive clamp, if an input signal of peak value 7V is applied with a bias of 4V?

Answer

Correct Answer: 18 V

Note: This Question is unanswered, help us to find answer for this one

4. If the H+ concentration is 3.0*10-3 M, then the pH value of a solution will be ____.

Answer

Correct Answer: 2.52

Note: This Question is unanswered, help us to find answer for this one

5.

State True/False:

When the Wheatstone bridge is balanced, the current through galvanometer is zero.


Answer

Correct Answer:

True 


Note: This Question is unanswered, help us to find answer for this one

6. Which of the following Boolean algebra expressions is incorrect?

Answer

Correct Answer: A.1 = 1

Note: This Question is unanswered, help us to find answer for this one

7.

This question is based upon the figure shown below

State True/False:

The Signal shown in the above image is periodic.


Answer

Correct Answer:

True 


Note: This Question is unanswered, help us to find answer for this one

8. Which of the following statements is false?

Answer

Correct Answer: A piezoelectric transducer has very low DC output impedance.

Note: This Question is unanswered, help us to find answer for this one

9. If 400 fringes cross the centre of the field of view by moving one mirror through a distance of 0.1347mm in a Michelson Interferometer, then what would be the wavelength of the light?

Answer

Correct Answer: 6735 Å (Angstrom)

Note: This Question is unanswered, help us to find answer for this one

10. What would be the cut-off frequency, if a low-pass filter is built with a 20 nF capacitor and a 10 KΩ resistor?

Answer

Correct Answer: 796.2 Hz

Note: This Question is unanswered, help us to find answer for this one

11. Which of the following statements is false about Voltmeter?

Answer

Correct Answer: Its resistance is very less.

Note: This Question is unanswered, help us to find answer for this one

12.

This question is based upon the figure shown below

From the above circuit diagram, what would be the approximate value of unknown voltage V1?

Answer

Correct Answer:

4V 


Note: This Question is unanswered, help us to find answer for this one

13.

This question is based upon the figure shown below

What would be the value of current through resistance R1 in the above circuit?

Answer

Correct Answer:

42.3 mA


Note: This Question is unanswered, help us to find answer for this one

14.

This question is based upon the figure shown below


To measure the capacitive impedance at a frequency of 3 kHz, a capacitance comparison bridge is used. Choose the correct equivalent series circuit of the unknown impedance if the bridge constants at bridge balance are given as:


C3 = 11 µF, R1 = 1.3 kΩ, R2 = 110 kΩ, R3 = 130 kΩ



Answer

Correct Answer:

2


Note: This Question is unanswered, help us to find answer for this one

15.

State True/False:

An operational amplifier produces an output voltage that is typically hundreds of thousands of times larger than the voltage difference between its input terminals.


Answer

Correct Answer:

True 


Note: This Question is unanswered, help us to find answer for this one

16. To convert a JK flip-flop into a T flip-flop, what would be the input values of J and K?

Answer

Correct Answer: J=K=1

Note: This Question is unanswered, help us to find answer for this one

17.

This question is based upon the figure shown below

An array from the polynomial s4 + 2s3 + 6s2 + 2s + 20 is given above to apply Routh criterion. What would be the value of the term indicated as "??" in the given array?

Answer

Correct Answer:

-6


Note: This Question is unanswered, help us to find answer for this one

18. Which of the following statements is false about Linear Convolution?

Answer

Correct Answer: The length of the output sequence will not be greater than the length of input sequences.

Note: This Question is unanswered, help us to find answer for this one

19. If a clamper has a capacitor of capacitance, C = 0.02µF and resistance, R=400 KΩ, then what would be the total discharge time for the capacitor?

Answer

Correct Answer: 40 ms

Note: This Question is unanswered, help us to find answer for this one

20.

This question is based upon the figure shown below

What would be the value of IC from the above circuit?

Answer

Correct Answer:

19.9 mA 


Note: This Question is unanswered, help us to find answer for this one

21.

This question is based upon the figure shown below

Which of the following is the simplified form of the Boolean expression as given in the above figure?

Answer

Correct Answer:

BC 


Note: This Question is unanswered, help us to find answer for this one

22.

This question is based upon the figure shown below

What would be the period (T) of the periodic signal as shown in the above image?

Answer

Correct Answer:

π/4


Note: This Question is unanswered, help us to find answer for this one

23. Which of the following statements is false?

Answer

Correct Answer: Hydraulic system is operated with compressed air while Pneumatic system is operated by pressurised oil.

Note: This Question is unanswered, help us to find answer for this one

24. A 3mA meter having internal resistance of 100 ohm is to be converted to 0-160mA ammeter. What would be the value of the shunt resistance required?

Answer

Correct Answer: 1.911 ohm

Note: This Question is unanswered, help us to find answer for this one

25.

Which of the following are the main modules of a mass spectrometer instrument?

I) Mass analyzer

II) Extraction system

III) Detector

IV) Ionizer


Answer

Correct Answer:

I, II, III, and IV


Note: This Question is unanswered, help us to find answer for this one

26.

This question is based upon the figure shown below

A potential divider circuit is given in the above figure. What would be its output voltage (Vout), if the supplied voltage (VS) is 8V?

Answer

Correct Answer:

2.29 V


Note: This Question is unanswered, help us to find answer for this one

27. Which of the following gates is a universal gate?

Answer

Correct Answer: NAND gate

Note: This Question is unanswered, help us to find answer for this one

28. An 8-bit digital to analog converter uses BCD input and produces a full-scale output of 9.90 Volt. What would be the analog output for the BCD input 1001 0101?

Answer

Correct Answer: 9.5V

Note: This Question is unanswered, help us to find answer for this one

29.

This question is based upon the figure shown below

A 4-bit serial-in parallel-out shift register is given in the above figure. Its initial contents are given as 0101. If three clock pulses (CLK) are applied then what would the final contents of the shift register be?

Answer

Correct Answer:

1010 


Note: This Question is unanswered, help us to find answer for this one

30.

This question is based upon the figure shown below

A four-arm a.c. bridge network is shown in the figure above whose arms PQ has a non-reactive resistor of 1400Ω in parallel with a condenser having capacitance of 0.5µF, QR has a non-reactive resistor of 700Ω, RS has an unknown inductive resistor and SP has a non-reactive resistor of 400Ω. If it is given that the network is balanced, what would be the values of the unknown resistance and inductance across RS?

Answer

Correct Answer:

Rx = 200Ω, Lx = 140 mH 


Note: This Question is unanswered, help us to find answer for this one

31. The meter constant of 6A, 220V dc watt-hour meter is 3365 revolutions per kWh. What would be the number of revolutions in one minute?

Answer

Correct Answer: 74.03 r.p.m

Note: This Question is unanswered, help us to find answer for this one

32. If a sinusoidal wave of angular frequency 1400 rad/s applied to the Y-Y plates of a Cathode Ray Oscilloscope produces six horizontal tangent points and five vertical tangent points, then what would be the frequency of the sinusoidal waveform applied to the X-X plates?

Answer

Correct Answer: 1680 rad/s

Note: This Question is unanswered, help us to find answer for this one

33.

State True/ False:

The system y(t) = 4x2(t) is time invariant.


Answer

Correct Answer:

True 


Note: This Question is unanswered, help us to find answer for this one

34. If the refractive indices for the core and cladding of an optical fibre are 1.7 and 1.5 respectively. What would be the acceptance angle of the optical fibre?

Answer

Correct Answer: 53.1 degree

Note: This Question is unanswered, help us to find answer for this one

35.

Which of the following statements is/are false?

(1) Fuzzy logic follows the principle of Aristotle and Buddha.

(2) The AND, OR, and NOT logical operators of Boolean logic are called Zadeh operators in Fuzzy logic.


Answer

Correct Answer:

(1) only


Note: This Question is unanswered, help us to find answer for this one

36.

A light dependent resistor has a resistance of 200 ohms at a certain light level. It can only handle a current of 20 milliamps before it risks heating up.

If the LDR (Light Dependent Resister) is connected to a 40V supply, what would be the value of resistor we place in series?


Answer

Correct Answer:

1800 ohms


Note: This Question is unanswered, help us to find answer for this one

37.

This question is based upon the figure shown below

In the above figure, initial value of the base current is 30 µA and the beta rating of the component is 300. If the base current (IB) increases from 30 µA to 60 µA, then what would be the change in the value of the collector current(Ic)?

Answer

Correct Answer:

9 mA 


Note: This Question is unanswered, help us to find answer for this one

38.

What would be the decimal number of the following excess-3 code?

Excess-3 code = 1010 0101


Answer

Correct Answer:

72 


Note: This Question is unanswered, help us to find answer for this one

39.

What would be the simplified form of the function given below using the Karnaugh map?

f=∑(0,3,7,11,14) + d∑(5,12,15)

(Where

Answer

Correct Answer:

C.D


Note: This Question is unanswered, help us to find answer for this one

search