When creating a sweep feature, you receive this error: "Cannot get to a point on the path to start with. For an open path, the path must intersect with the section plane." How can you fix this?

With injection molding, one common manufacturing requirement or preference is applying a taper or angle to faces to help with part removal from the mold. Which feature can help you meet this requirement?

You want to simplify a very large and complex assembly to improve performance while working within it. What should you use?

If you are working with ISO standards, which projection method would you most likely be using?

You have a single line within a sketch that you would like to split into three separate lines. How can you achieve this?

What controls the direction and magnitude of a spline curvature?

How does SolidWorks store parts?

What SolidWorks module do you use to analyze fluid dynamics?

SolidWorks motion allows users to simulate all of the following except...

Can you use a design table to create a new configuration?

What do you need to do before evaluating the mass of a part?