With injection molding, one common manufacturing requirement or preference is applying a taper or angle to faces to help with part removal from the mold. Which feature can help you meet this requirement?

You want to simplify a very large and complex assembly to improve performance while working within it. What should you use?

If you are working with ISO standards, which projection method would you most likely be using?

You have a single line within a sketch that you would like to split into three separate lines. How can you achieve this?

What controls the direction and magnitude of a spline curvature?

You want to build a new part within an assembly to ensure in-context relations and dimensions. You also want to save out this part file as its own unique file. After navigating to the Assembly ribbon tab, what do you do next?

What SolidWorks module do you use to analyze fluid dynamics?

SolidWorks motion allows users to simulate all of the following except...

Can you use a design table to create a new configuration?

What do you need to do before evaluating the mass of a part?

Which feature do you use to create a tapped hole?