SolidWorks MCQs (Chapterwise Multiple Choice Questions)

With injection molding, one common manufacturing requirement or preference is applying a taper or angle to faces to help with part removal from the mold. Which feature can help you meet this requirement?

Loft

Draft

Wrap

Sweep

Answer & Explanation

Correct Answer: Draft

Note: This Question is unanswered, help us to find answer for this one

Can you mirror bodies?

No, never

Yes, always

No, except for molds

Yes, but only sheet metal

Answer & Explanation

Correct Answer: Yes, always

Note: This Question is unanswered, help us to find answer for this one

Can you create a sheet metal flange using a curved edge?

Yes

No

Answer & Explanation

Correct Answer: Yes

Note: This Question is unanswered, help us to find answer for this one

How can you reattach a broken reference in a derived split part?

Right-click the filename at the top of the FeatureManager design tree and select Relink Stock Part.

Once derived part references are broken, they cannot be readded. Consider resplitting the part.

Locate the child part using SOLIDWORKS Explorer and select Relink Parent.

Edit the stock feature at the start of the FeatureManager design tree, then adjust the Defining Stock Part option.

Answer & Explanation

Correct Answer: Edit the stock feature at the start of the FeatureManager design tree, then adjust the Defining Stock Part option.

Note: This Question is unanswered, help us to find answer for this one

If a part is rolled back to an old state and then a feature is added, when the part is rebuildt...

The new feature will be present, and any interfering features will be deleted

Parts cannot be rolled back to an old state

There may be rebuild errors if the new feature interferes with a later feature

The new feature and old features will both be there, even if they interfere with each other

Answer & Explanation

Correct Answer: There may be rebuild errors if the new feature interferes with a later feature

Note: This Question is unanswered, help us to find answer for this one

Which of the following sketch entities needs to be avoided when defining hole positions in Hole Wizard?

Polygon

Center Point Arc

Perimeter Circle

Center Rectangle

Answer & Explanation

Correct Answer: Center Rectangle

Note: This Question is unanswered, help us to find answer for this one

Which sketch relation can you NOT apply to a rectangle?

Coincident

Collinear

Concentric

Fix

Answer & Explanation

Correct Answer: Concentric

Note: This Question is unanswered, help us to find answer for this one

What command do you initiate for a collision detection in an assembly?

Move Component or Rotate Component

Mate or Hole Wizard

Sketch or 3D Sketch

Mate or Mirror Components

Answer & Explanation

Correct Answer: Move Component or Rotate Component

Note: This Question is unanswered, help us to find answer for this one

What can be used as a split element?

A plane

A track

A vertex

A body

Answer & Explanation

Correct Answer: A plane

Note: This Question is unanswered, help us to find answer for this one

What does the rip command do?

It copies an entire feature from one surface and pastes it on another

It separates a solid into a multi-body solid

It creates a relief gap necessary for the manufacturing of sheet metal

It breaks a solid along a corner to make it suitable for adding bends

Answer & Explanation

Correct Answer: It breaks a solid along a corner to make it suitable for adding bends

Note: This Question is unanswered, help us to find answer for this one

SolidWorks Quick Quiz

Poor Results!

You need a lot of improvement.

Just don't give up!

Correct Answers: 0/10

Start Practicing with our MCQs given below.