When you create a boss-extrude, what parameters you can specify?

Which feature do you use to create a tapped hole?

What do you need to do before evaluating the mass of a part?

Can you use a design table to create a new configuration?

SolidWorks motion allows users to simulate all of the following except...

What SolidWorks module do you use to analyze fluid dynamics?

You want to build a new part within an assembly to ensure in-context relations and dimensions. You also want to save out this part file as its own unique file. After navigating to the Assembly ribbon tab, what do you do next?

What controls the direction and magnitude of a spline curvature?

You have a single line within a sketch that you would like to split into three separate lines. How can you achieve this?

If you are working with ISO standards, which projection method would you most likely be using?

You want to simplify a very large and complex assembly to improve performance while working within it. What should you use?