__________ is the angle made by the face of the tool and the parallel plane to the base of the cutting tool.

What type of gear is used to transmit power at constant velocity ratio between two shafts the axes of which intersect at an angle?

Which technique is known as 'time phase of loading'.

The process of heating the metal to the plastic state followed by application of pressure to form the molten metal into desired shape is known as ________.

The radius of a shaft is 5 millimeters. The shear stress on that shaft is 50 newtons per square millimeter and the polar moment of inertia is 10 (millimeters)4. Calculate the twisting moment on that shaft.

If L is the length of the journal and d is the diameter of the journal then, in a square bearing:

Shear deflection of a cantilever of length L, cross sectional area A and shear modulus G, under a concentrated load W at its free end, is

If two forces acting at a joint are not along the straight line, then for the equilibrium of the joint

In the given below figure, the rivets with maximum stress, are:

In actual machines

In a loaded beam, the point of contraflexure occurs at a section where