Your sketch is not extruding correctly. It does not seem to be a properly closed contour, although from a simple visual inspection, it looks to be fully closed. You think perhaps there are some very small gaps in your contour that are causing the issue. What tool can you use to find these small gaps?

Which choice is an example of a skected feature?

You want to make two circles have the same center point within a SOLIDWORKS sketch. How can you do this?

Which reference geometry is NOT available in SOLIDWORKS?

Specifying two lines to be perpendicular to each other would be an example of what?

You want to focus on a single component within your assembly and hide all the rest. How can you do this?

What tool do you use to project an existing geometry onto the sketch plane?

What software should be used to make realistic renderings of SolidWorks parts and assemblies?

Using an assembly design table , you can create configurations of an assembly with different mating conditions

When you start a new sketch, what sketch types do you select from?

Is it possible to have a multi-bodied sheet metal part?