Computer Technician Quiz # 4

Instructions
Quiz: Computer Technician Quiz # 4
Subject: Basic Computer Technician
Total Questions: 30 MCQs
Time: 30 Minutes

Note

  • Do not refresh the page while taking the test.
  • Results along with correct answers will be shown at the end of the test.
Computer Technician Quiz # 4
Question 1 of 30
00:00
  • What does "baud rate" mean?


  • Which IRQ does LPT 2 use?


  • What can be the maximum distance between an IrDA (Infra Red) printer and an IrDA capable laptop?


  • Which of the following supports a data transfer rate of 800 Mbps?


  • How many interrupt requests does an Intel 8259s based computer have?


  • What does SMPS stand for?


  • Fill the blank with the most appropriate option.

    The parallel port uses a _____cable connector.


  • Which of the following transmission media provides the maximum transmission distance?


  • On which ports are internal modems generally installed?


  • How is a "floppy disk write" protected?


  • What will you do if none of the USB devices work on any USB ports of a PC with newly installed operating system?


  • Is the following statement true or false?

    RISC processors are better at number crunching than CISCs are.


  • What will you do if documents printed by an ink jet printer appear to be blurred?


  • Which of the following commands will you use to clean a hard disk that is infected with a boot sector virus?


  • What is the maximum transmission distance of 1000 Base-T UTP cable?


  • What is "burst mode"?


  • Which of the following statements is false?


  • Fill in the blank with the most appropriate option.

    RAM and cache memory speeds are generally measured in ________.


  • Which IRQ and port address does COM 1 use?


  • When would you wear an anti-static wrist band?


  • Which of the following transmission media is immune to EMI (Electro Magnetic Interference)?


  • What part of a computer is a UART chip associated with?


  • What is the bandwidth supported by 168 pin and 184 pin DIMM modules?


  • Which of the following must be done to configure SCSI devices properly?


  • Fill the blank with the most appropriate option.

    RAM is a _____ storage device.


  • What does EDO stand for?


  • What does SCSI stand for?


  • What is the maximum transmission speed of CAT 5 cable?


  • Which of the following is a fiber optic connector?


  • What is a null modem?


Liked this quiz? Share it with friends:

Computer Technician Skill Assessment

Overall Skill Level-Poor

Your Skill Level: Poor

Retake Quizzes to improve it

Computer Technician Skill Assessment

Overall Skill Level-Poor

Your Skill Level: Poor

Retake Quizzes to improve it