CISCO Quiz # 3

Instructions
Quiz: CISCO Quiz # 3
Subject: Basic Cisco
Total Questions: 30 MCQs
Time: 30 Minutes

Note

  • Do not refresh the page while taking the test.
  • Results along with correct answers will be shown at the end of the test.
CISCO Quiz # 3
Question 1 of 30
00:00
  • What is the maximum number of subnets (usable) that you can create in a class B network?


  • Which command will apply access-list 150 on interface e0 in outbound direction?


  • Which command will you execute to use 16 subnets of a class C network with subnet mask of 255.255.255.240?


  • What is the correct order of data encapsulation in OSI model?


  • What is the Administrative Distance (AD) of OSPF?

  • Which of the following switching methods forward the frame after reading the destination MAC address only?


  • If a router has been configured for static routing, IGRP, OSPF, EIGRP and RIP with their default values, which routing will the router use to send data?


  • In which of the following networks, are DR and BDR elected in OSPF?


  • Which of the following statements is true regarding VLAN 1?


  • Which of the following devices is used to connect a non ISDN device with an ISDN network?


  • Which of the following statements are true for inter VLAN communication?


  • What should be the value of configuration register in a router to boot IOS image stored in ROM?


  • Which of the following provides routing protocol support for IPX, Appletalk and IP networks simultaneously?


  • What is the maximum number of paths supported by IGRP for load balancing?


  • Which of the following subnet masks should you use on Router A and Router B serial links so that there is minimum wastage of IP addresses?


  • What is the command to delete the configuration stored in NVRAM?


  • What is the default number of commands that a router can show if you execute 'show history' command?


  • Which of the following cables is not prone to electrical interferences?


  • What is the subnetwork to which IP address 10.70.50.255/18 belongs?


  • Which of the following routing protocols support VLSM?

  • Which of the following devices can be connected using a Rollover cable?

  • Which of the following ranges are reserved as private addresses?

  • Which two factors are used by default for calculation of metric by EIGRP?

  • Which of the following routing protocols are not classless routing protocols?

  • Which of the following Protocols work on Application Layerr of OSI model?

  • Which two statements are true about CHAP authentication method?

  • Which of the following routing protocols are distance vector routing protocols?

  • Which command is used to encrypt all the passwords of a router?

  • Which subnet mask will you use to fulfill the requirements of all the departments if you are using a class C network?

  • Which of the following addresses is reserved for loopback tests?

CISCO Skill Assessment

Overall Skill Level-Poor

Your Skill Level: Poor

Retake Quizzes to improve it

CISCO Skill Assessment

Overall Skill Level-Poor

Your Skill Level: Poor

Retake Quizzes to improve it