Correct Answer: they are not suitable for high frequency applications
Explanation:
Note: This Question is unanswered, help us to find answer for this one
PCB Design Skill Assessment
Your Skill Level: Poor
Retake Quizzes to improve it
More PCB Design MCQ Questions
How much copper surface is reserved on multilayer boards for the solderability test?
The fundamental principle of electrolysis is understood from
If Ohmic losses are neglected, the wave impedance Zw in a homogenous material can be calculated by using the formula.
What would be the simplest and most suitable remedy for electro-magnetic coupling between two wires?
It is a common experience of electronic circuit designers that at high frequency{>10 MHz), amplifiers behave as _____.
Which of the following techniques is used in mass soldering?
The dielectric constant of any material is also referred to as _____.
Copper plating is done in multilayer boards to _____.
In fast signal or high – speed logic circuits , the conductors are considered to be _____.
Which of the following is not a physical characteristic of a copper clad laminate?