On a PCB, the low power part and the high power part have to be spread sufficiently to avoid _____.

To overcome the motorboating effect, we must _____.

If a ground line is kept close to a signal line, crosstalk would be _____.

Which of the following is a type of soldering fluxes?

Under which of the following conditions is a multilayers board used?

Fabrication of PCBs for microwave use requires

The volume resistivity of a laminate is given by

For the etching process, the temperature should preferably be around

Which of the following is a category of dry film resists?

Which of the following is not a solder alloy?

By which material is the typical resin/filler laminate of ordinary PCBs replaced in metal core boards?