Correct Answer: l > Tr/100 nsec ( Tr- rise time of pulse)
Explanation:
Note: This Question is unanswered, help us to find answer for this one
PCB Design Skill Assessment
Your Skill Level: Poor
Retake Quizzes to improve it
More PCB Design MCQ Questions
Which of the following is not a physical characteristic of a copper clad laminate?
In fast signal or high – speed logic circuits , the conductors are considered to be _____.
Copper plating is done in multilayer boards to _____.
The dielectric constant of any material is also referred to as _____.
Which of the following techniques is used in mass soldering?
It is a common experience of electronic circuit designers that at high frequency{>10 MHz), amplifiers behave as _____.
What would be the simplest and most suitable remedy for electro-magnetic coupling between two wires?
If Ohmic losses are neglected, the wave impedance Zw in a homogenous material can be calculated by using the formula.
The fundamental principle of electrolysis is understood from
How much copper surface is reserved on multilayer boards for the solderability test?