In which among the following wage incentive plans is the worker paid according to the number of units of work produced by him?

In which, engine strokes, is the firing of the vaporized fuel carried out?

The process to improve the fatigue resistance in metals by producing compressive stresses in its surface is known as ________.

Due to which properties does molding sand adhere to the sides of the molding box?

Calculate the number of joints in a chain if the number of links is 5.

Calculate the strain in a material whose original length before undergoing strain is 10 centimeters and the length after undergoing strain is 100 centimeters.

The C.G. of a plane lamina will not be at its geometrical centre in the case of a

A cantilever carries is uniformly distributed load W over its whole length and a force W acts at its free end upward. The net deflection of the free end will be

The B.M. of a cantilever beam shown in below figure at A, is

A flywheel on a motor goes from rest to 1000 rpm in 6 sec. The number of revolutions made is nearly equal to

The maximum deflection of