An ideal amplifier has the _____.

In the transistor circuit shown in the figure, the collector-to-ground voltage is 20V. Which of the following is the probable cause of the error?

Which amplifiers is designed to operate digital signals?

Refer to the given image: The circuit shown in the image has a zener regulated D.C power supply. Assuming that the zener diode is ideal, the minimum value of RL due to which the output voltage would remain constant will be ________.

What would be the input impedance of an ideal op-amp?

The application where one is most likely to find a quartz oscillator would be _____.

The transformer is used for impedance matching . It is expected to match 1296Ω resistance on the primary side to a 16Ω resistance on the secondary side. Calculate the required turn ratio of a transformer, what is the type of transformer?

For a full wave controlled rectifier using SCR, the average load voltage is________. (VLdc )

To generate 1KHz frequency of oscillations, the most suitable circuit is _____.

The output impedance of an operational amplifier is _____.

The application where one is most likely to find a quartz oscillator would be _____.